Differences

This shows you the differences between two versions of the page.

--- sdf_s_vpn_servers [2021/03/21 00:21] – [Connecting in FreeBSD] hc9
+++ sdf_s_vpn_servers [2021/03/21 00:29] (current) – [Connecting in FreeBSD] hc9
@@ Line 311: / Line 311: @@
     - Your USERNAME
     - Your PASSWORD
-    - The local address of SDF's VPN host. This can be found in /etc/hosts on SDF. The local IP will start with 10.0.0, but have the same last octet as the public IP.
+    - The local address of SDF's VPN host. This can be found in ''/etc/hosts'' on SDF. The local IP will start with 10.0.0, but have the same last octet as the public IP.
-  * Add this in your /usr/local/etc/mpd4/mpd4.links file: <code>
+  * Add this in your ''/usr/local/etc/mpd4/mpd4.links'' file: <code>
   sdfvpn:
           set link type pptp
@@ Line 320: / Line 321: @@
 </code>
   * You will have to replace one (1) thing in this config:
-    - The public address of SDF's VPN host. You can get this by running setvpn at the shell.
+    - The public address of SDF's VPN host. You can get this by running ''setvpn'' at the shell.
-  * Now, as root, run mpd4 sdfvpn.
+  * Now, as root, run ''mpd4 sdfvpn''.
   * You should now be connected to SDF over a layer 3 tunnel across the Internet.
   * Your new routes are only for SDF's hosts, and use their internal IP addresses. These are the 10.0.0.x ones. I'm working on how to route to the public ones over the VPN without creating a routing loop to the VPN host. I copied SDF's /etc/hosts file to my machine so that I can run 'ssh sdf1' to connect through the tunnel.