sdf_s_vpn_servers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
sdf_s_vpn_servers [2021/03/20 23:58] – [Installing OpenVPN] hc9 | sdf_s_vpn_servers [2021/03/21 00:17] – hc9 | ||
---|---|---|---|
Line 177: | Line 177: | ||
ip route del $SDFVPNHOST via $VIA dev $DEV table sdftun | ip route del $SDFVPNHOST via $VIA dev $DEV table sdftun | ||
</ | </ | ||
- | + | * This automatically detects the default gateway and adds appropriate routes, starts the VPN and deletes the routes after VPN has been stopped. If you do not use a custom routing table dedicated to the SDF VPN you should delete the lines ending in "table sdftun" | |
- | This automatically detects the default gateway and adds appropriate routes, starts the VPN and deletes the routes after VPN has been stopped. If you do not use a custom routing table dedicated to the SDF VPN you should delete the lines ending in "table sdftun" | + | |
==== GUI Setup With NetworkManager ==== | ==== GUI Setup With NetworkManager ==== | ||
Line 198: | Line 197: | ||
{{ : | {{ : | ||
- | Click on the **Add** button, and choose **Point-to-Point Tunneling Protocol (PPTP)**, then click **Create**. Fill out the **User name**, **Password** and **Gateway** fields with appropriate values ([[#setup|from when you ran //setvpn//]]): | + | Click on the **Add** button, and choose **Point-to-Point Tunneling Protocol (PPTP)**, then click **Create**. Fill out the **User name**, **Password** and **Gateway** fields with appropriate values ([[#setting_it_up|from when you ran setvpn]]): |
{{ : | {{ : | ||
Line 264: | Line 263: | ||
RX bytes:1159 (1.1 KiB) TX bytes:128 (128.0 B) | RX bytes:1159 (1.1 KiB) TX bytes:128 (128.0 B) | ||
</ | </ | ||
- | - Routing can be set up like any Linux OS, so follow the routing instructions found above: [[#linux|Linux]]. | + | - Routing can be set up like any Linux OS, so follow the routing instructions found above: [[#connecting_in_linux|Linux]]. |
==== PPTP Userspace Utility ==== | ==== PPTP Userspace Utility ==== | ||
Line 270: | Line 269: | ||
- Login to your OpenWRT device via SSH. | - Login to your OpenWRT device via SSH. | ||
- Install the required userspace tools and module for MPPE: //opkg install pptp kmod-mppe// | - Install the required userspace tools and module for MPPE: //opkg install pptp kmod-mppe// | ||
- | - Follow the [[#linux|Linux]] directions above like normal. | + | - Follow the [[#connecting_in_linux|Linux]] directions above like normal. |
- If you are still having trouble, look over the official OpenWRT documentation found here: http:// | - If you are still having trouble, look over the official OpenWRT documentation found here: http:// | ||
===== Connecting in FreeBSD ===== | ===== Connecting in FreeBSD ===== | ||
- | * Install mpd4 from ports or packages. | + | * Install |
- | * Add the following section to your / | + | * Add the following section to your '' |
< | < |
sdf_s_vpn_servers.txt · Last modified: 2021/03/21 00:29 by hc9